Search results for "polyvinyl alcohol"

In Vitro Percutaneous Penetration of Acyclovir from Solvent Systems and Carbopol 971-P Hydrogels: Influence of Propylene Glycol

2005

The mechanism underlying propylene glycol (PG) effects on acyclovir (ACV) penetration through human epidermis were studied. Solvent systems and Carbopol gels containing increasing percentage of PG (from 0% to 70%, w/w) were used. Viscosity studies of both vehicles were carried out to characterise the influence of rheological behaviour. In solvent systems skin permeation values of ACV increase as the concentration of PG increase yielding a maximum enhancement ratio (ER = 10) for 70% PG. The release rate of ACV from gels was determined. Higuchi's model was used to estimate the apparent diffusion coefficient of the drug. These values show a decrease as the content of PG in the vehicle increase…

Polysorbate 80 controls Morphology, structure and stability of human insulin Amyloid-Like spherulites

2022

AbstractAmyloid protein aggregates are not only associated with neurodegenerative diseases and may also occur as unwanted by-products in protein-based therapeutics. Surfactants are often employed to stabilize protein formulations and reduce the risk of aggregation. However, surfactants alter protein-protein interactions and may thus modulate the physicochemical characteristics of any aggregates formed. Human insulin aggregation was induced at low pH in the presence of varying concentrations of the surfactant polysorbate 80. Various spectroscopic and imaging methods were used to study the aggregation kinetics, as well as structure and morphology of the formed aggregates. Molecular dynamics s…

1979

The demixing behavior of 20 representatives of the system oligo(dimethylsiloxane)/oligo(propylene glycol) (ODMS/OPG)1 is investigated at pressures up to 1 500 bar. The degrees of oligomerization range from 2 to 5 for the first and from 1 to 57, 6 for the second component. The experimental results are compared with those for the previously studied system oligoisobutene/oligo(propylene glycol) (OIB/OPG). In both cases the observed upper critical temperatures Tc increase with the number of monomeric units of the less polar component, whereas they run through a minimum when the number of monomeric units of the glycol is raised. For the present system the Tc values are found to be considerably h…

Scalable heterogeneous synthesis of metallic nanoparticles and aggregates with polyvinyl alcohol

2009

Here we report on a new route to synthesize colloidal silver and gold nanoparticles, potentially scalable for massive nanoparticle-production. This method is based on the microwave-assisted heterogeneous reduction of the metal salts with polyvinylalcohol. The reaction is carried out in alcohols, which are non-solvents for polyvinylalcohol. Nanoparticles can be very easily separated by filtration. The reaction kinetics are extremely fast. Size-controlled formation of nanoparticle agglomerates is accomplished with a seed-mediated synthesis of nanoparticles upon MW exposure.

Effects of polysorbate 80 on amiodarone intestinal absorption in the rat

1995

Abstract Amiodarone is a widely used anti-arrhythmic agent which shows physico-chemical properties that are highly suitable for diffusion across lipophilic absorbing membranes, however,.its low aqueous solubility could represent the rate-limiting step for absorption, making it erratic and variable. In a previous paper, the influence of an anionic surfactant (sodium lauryl sulphate) at variable supramicellar concentrations was studied. The absorption rate constants of amiodarone decreased as the surfactant concentration increased, and absorption was unusually fast at lower surfactant concentrations. The previously proposed equations for interpreting the relationships between the amiodarone a…

Evaluation of molecular mass and tacticity of polyvinyl alcohol by non-equilibrium capillary electrophoresis of equilibrium mixtures of a polymer and…

2011

Non-equilibrium capillary electrophoresis of equilibrium mixtures (NECEEM) has been used to characterize polyvinyl alcohol (PVA). Commercial PVA samples with different molecular masses, from M(w)=15 up to 205 kDa, were used. According to the (13)C NMR spectra, the samples also differed in tacticity (stereoregularity). Mixtures of PVA and the anionic azo-dye Congo Red (CR) were injected in the presence of a borate buffer. The electropherograms gave a band and a peak due to the residual PVA-CR complex and the excess dye, respectively, plus a superimposed exponential decay due to the partial dissociation of the complex during migration. The stoichiometry of the PVA-CR complex, q=[monomer]/[dye…

Loading profile of topotecan into polyvinyl alcohol microspheres (DC Bead™) over a 7-day period

2011

Purpose: DC Bead™ is successfully used for chemoembolization of various liver cancers. The purpose of this study was todetermine the loading capacity of the semi-synthetic topoisomerase-1 inhibitor topotecan into the DC Bead™ microspheres under static or agitated conditions and to assess the physicochemical stability over a period of 7 days. Methods: Commercially available topotecan hydrochloride powder (Hycamtin®) was reconstituted with water for injection to yield a nominal concentration of 1 mg/mL topotecan. Polyvinyl alcohol (PVA)-based microspheres (DC Bead™, 300–500 µm, 2 mL/vial) were mixed with 4 mL of the reconstituted topotecan solution. Vials were stored light protected at room …

3D-Printed Solid Dispersion Drug Products.

2019

With the well-known advantages of additive manufacturing methods such as three-dimensional (3D) printing in drug delivery, it is disappointing that only one product has been successful in achieving regulatory approval in the past few years. Further research and development is required in this area to introduce more 3D printed products into the market. Our study investigates the potential of fixed dose combination solid dispersion drug products generated via 3D printing. Two model drugs&mdash

Effects of confinement on insulin amyloid fibrils formation.

2006

Insulin, a 51-residue protein universally used in diabetes treatment, is known to produce amyloid fibrils at high temperature and acidic conditions. As for other amyloidogenic proteins, the mechanisms leading to nucleation and growth of insulin fibrils are still poorly understood. We here report a study of the fibrillation process for insulin confined in a suitable polymeric hydrogel, with the aim of ascertain the effects of a reduced protein mobility on the various phases of the process. The results indicate that, with respect to standard aqueous solutions, the fibrillation process is considerably slowed down at moderately high concentrations and entirely suppressed at low concentration. M…

Twisting and buckling: A new undulation mechanism for artificial swimmers

2012

Among the various locomotion strategies of the animal kingdom, the undulation locomotion is of particular interest for biomimetic applications. In this paper, we present an artificial swimmer set into motion by a new and non-trivial undulation mechanism, based on the twisting and buckling of its body. The swimmer consists of a long cylinder of ferrogel which is polarized transversely and in opposite directions at each extremity. When it is placed on a water film and submitted to a transverse oscillating magnetic field, the worm-like swimmer undulates and swims. Whereas symmetry breaking is due to the field gradient, the undulations of the worm result from a torsional buckling instability as…